TTT Footprint
Bid x ask footprint with a delta-coloured histogram, POC, diagonal imbalances and stacked-imbalance zones. Built from tick data.
Video
How to use it
The full walkthrough: setting it up, the settings that matter, and how I read it on real ES sessions.
More on the channelHow to use TTT Footprint
The step-by-step video is being recorded. Subscribe and you'll see it first.
Subscribe on YouTubeWhat it shows
Features
Bid x ask at every price
Every trade is classified as a buyer or seller from the bid and ask at that moment, then added up per price inside each bar. Switch the text between bid x ask and delta.
Histogram that shows who won
Each price gets a bar sized by volume (or delta), green where buyers won and purple where sellers did, brighter the bigger the delta.
POC and diagonal imbalances
The bar's point of control is boxed. Diagonal imbalances (ask vs bid one tick below, 300% by default) are highlighted in cyan and magenta.
Stacked imbalance zones
Three or more imbalances in a row make a thin zone that extends right until price trades back through it, so you can see which ones held.
Bar totals
Volume, delta and delta % under or over every bar.
Any chart
Works on minute, range, tick or volume bars. Zoomed out, it turns into clean candles; zoom in and the numbers appear when they fit.
Guide
How to trade it
How to read it
Start with the histogram colour. A bar that is mostly green at its highs and purple at its lows is being bought up; the opposite is being sold down. The POC box shows where most of the bar’s volume traded.
Imbalances show where one side was far more aggressive than the other. A single one means little. Stacked imbalances (three or more in a row) show a whole price area where one side took everything, and that is why they become zones.
How I use it
- I watch what happens when price comes back to a stacked imbalance zone. If it holds and the new bar shows the same side stepping in, the zone did its job. If price trades straight through, the zone ends and I stop caring about it.
- At the high or low of a move, I look for big volume with little progress: lots of buying at the top of an up bar that can’t push higher.
- I pair it with TTT Big Trades so the large orders show on top of the footprint.
This is how I read it, not a signal. Practise on Market Replay before you trade it live.
Settings
The ones that matter
Every setting has a description inside NinjaTrader too. These are the ones worth changing.
| Setting | What it does |
|---|---|
| Imbalance ratio | 3 = 300%. Ask at a price against bid one tick below (buyers), bid against ask one tick above (sellers). |
| Imbalance min volume | The winning side needs at least this many contracts. |
| Text | BidAsk shows bid x ask at each price. Delta shows ask minus bid. |
| Histogram | Volume = bar length is the volume at the price. Delta = length is the delta. |
| Show numbers | Auto shows numbers only when they are readable. Show = always, Hide = histogram only. |
| Stacked levels | How many imbalances in a row make a zone (3 by default). |
| Zone ends on | Cross = a later bar trades through the zone. Touch = a later bar reaches it. |
Requirements
What you need
- Platform
- NinjaTrader 8 (free licence works)
- Data
- Tick data (any CME data feed). No Order Flow+ needed.
- Tested on
- ES · NQ · MES · MNQ
- In NinjaTrader
- Indicators → TradeTheTicks (TTTFootprint)
- Version
- v1.0.0 · Dec 1, 2026
Do I need the Order Flow+ licence?
No. TTT Footprint builds the footprint itself from a 1-tick data series, so it works on the free NinjaTrader licence and on prop firm logins.
Why don't I see numbers?
Numbers only appear when they fit. Widen the bars (Ctrl + mouse wheel, or the chart's Bar width) and zoom in on price.
Will the numbers match NinjaTrader's own footprint exactly?
Very close, but trades inside the spread are classified by the tick rule, so a few prices can differ by a contract or two.
Changelog
Versions
- v1.0.0Dec 1, 2026First release.
Works well with